Installation diagram of single screw insulated puncture clamp
1. Adjust the puncture wire clamp nut to a suitable position, and insert the branch line into the branch line cap completely.
2. Insert the main wire. If the main wire has two layers of insulation, peel the outer insulation of a certain length at the connection position.
3. Put the main / branch line in the proper position and keep it parallel. First, tighten the nut by hand to fix the wire clamp.
4. Tighten the nuts evenly with a sleeve wrench of the corresponding size until the top breaks and comes off, and the installation is complete.
Installation diagram of twin screw insulation piercing clamp
1. Unscrew the wire clamp and snap the main wire into the main wire groove. Do not skew the main wire and the knife ruler. Pay attention to whether the diameter range corresponds to this clamp.
2. Put the branch line into the branch line slot. Note the same as above.
3. Tighten with a socket wrench. Disable open-end wrenches.
4. Note that the two nuts must be screwed down in sequence.
5. When tightening to a certain force, the constant torque nut is broken. The installation is complete.
Post time: Aug-23-2022